Diverses Zubehör für die Kompakt-SPS
Extension cable for Kinco MK series - with 2 x RS-485 socket
€48.00*
With this extension cable, the devices of the MK series from Kinco, a combination device of HMI and PLC can be connected with the extensions. The extensions he Kinco KS-PLC series can be used so easily with the MK series. Internally MK-PLC and extension are connected via a CAN protocol, but this does not need to be programmed, it is sufficient to configure the extensions in the hardware configuration of the PLC in Kinco Builder.On the last extension should be activated via the DIP switches the end resistor.The extension cable is high quality with metal connector on HMI PLC side. In addition, the two RS-485 interfaces of MK-PLC are via a connector with screw contacts. This can be used to connect other Modbus devices or serial devices to MK-PLC.This cable is a service product for easier connection. You can also easily assemble your own cable for the extension. You can find the correct PIN assignment in the product photos.
- Available
- Delivery Time : 2-5 days
LED push button 19 mm blue
€8.40*
LED pushbutton blue 19 mm maximum IP67 switches up to 5 A / 250 VAC contact configuration: 1NO1NCsuitable for all PLCs
- Available
- Delivery Time : 3 Tage
Serial connection cable (RS-485) for Kinco CV20 frequency converter and Kinco HMI
€18.00*
This serial connection cable enables the Kinco HMI to communicate with Kinco CV20 frequency inverters.Through the HMI, the frequency inverters can be parameterized and controlled with this cable.Using special Modbus commands, the frequency inverters can be started and stopped, the direction can be reversed and the frequency can be specified.
- Available
- Delivery Time : 2-5 days
- Product Benefits 1: CV20 und HMI verbinden
- Product Benefits 2: über HMI parametrieren
- Product Benefits 3: über HMI ansteuern
Serial connection cable (RS-485) for Kinco CV20 frequency converter - open ends
€12.00*
This serial interconnect cable enables Kinco's CV20 frequency inverters to communicate via Modbus RTU in an RS-485 serial bus.Using special Modbus commands the frequency inverters can be started and stopped, the direction can be reversed and the frequency can be specified.
- Available
- Delivery Time : 2-5 days
- Product Benefits 1: CV20 über RS-485 verbinden
- Product Benefits 2: über Modbus RTU ansteuern
Radio clock receiver (DCF77) for SPS as kit
€82.35*
Radio clock receiver (DCF77) for synchronizing real-time clocks in the PLC with the time signal24 VDC pulses transmit the time signal and can be easily connected to a 24 VDC signal input of a PLC.Supplied with: DCF receiver and circuit board for signal transmission to PLC (24 VDC)A ready-to-use program for synchronizing the real-time clock of the Thinget PLC with the time signal is available free of charge as a download here:
- Available
- Delivery Time : 15 days